Appendix 2: How To Install The Safety Extension Unit - Mitsubishi Electric MELFA CR800 Series Instruction Manual

8 APPENDIX

8.2 Appendix 2: How to Install the Safety Extension Unit

As a metal plate to install the safety extension unit, install a metal plate of the following size or smaller.
Where to install: Studs in the lower part of the door (four locations)
Metal plate installation pitch and screw size: 188mm×90mm (M4 screws)
Metal plate installation size: 200mm×116mm or less
Installation height: 50mm or less
Installation thickness: 1.2mm to 1.6mm
Use the following steps for the installation.
1) A metal plate with a size of 200mm×116mm or less can be installed.
Prepare the metal plate as shown in the figure below (metal plate installation pitch: 188mm×90mm, M4
screws).
8-128 Appendix 2: How to Install the Safety Extension Unit