Table of Contents
Advertisement
Temp Fault
Ground Fault
Over Load Fault
Eps Over Load
Bat Power Low
HW Bus Vol Fault
HW Pv Cur Fault
HW Bat Cur Fault
SCI Fault
MDSP SPI Fault
MDSP Smpl Fault
The inverter temperature is high.
• Please check if the environment temperature.
• Wait for a while to check if back to normal.
• Or seek for help from us.
The ground connection is failed.
• Check the voltage of neutral and PE.
• Check AC wiring.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
Over load in on grid mode.
• Please check if the load power exceeds the limit.
• Or seek for help from us.
Over load in off grid mode.
• Please check if the eps load power exceeds the limit.
• Or seek for help from us.
The battery power is low.
• Wait the battery to be recharged.
• Or seek for help from us.
Bus voltage out of range detected by hardware.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
PV input current high detected by hardware.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
Battery current high detected by hardware.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
The communication between master and manager is fail.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
The communication between master and slave is fail.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
The master sample detection circuit is failed.
• Disconnect PV, grid and battery, then reconnect.
• Or seek help from us, if not go back to normal state.
40
Advertisement
Table of Contents
