Troubleshooting - DCS BH1-48RI-N User Manual

Why is the burner flame yellow/orange?
Burner needs to be adjusted. See Install Guide.
Why won't the burners light when I turn the dial?
Dial not pushed in when attempting to light grill. Push and turn to
z
'Using the grill.'
Gas supply is turned off. Turn gas on.
z
Burner inlet or tube may be blocked. Remove burner and check for blockages. See
z
'Cleaning the grill burners', 'Cleaning the sear burner' or 'Cleaning the side burners.' If
problem persists, call Customer Care or your Authorized Service Center.
Ignitor battery is flat or ignitor has failed. Check if ignitor clicks when you push dial.
z
If not, replace battery. See 'Replacing the light and battery.' If problem persists, call
Customer Care or your Authorized Service Center.
Why does the grill keep having flare-ups?
Radiant trays have grease on them. Wait for trays to cool, then rotate ceramic rods
z
and heat on for 10-20 minutes. See 'Cleaning.'
HI
Sear burner has grease on it. See 'Cleaning the sear burner.'
z
Rotisserie burner has grease on it. See 'Cleaning.'
z
Why can I smell gas?
Burner dial is on but burner is not lit. Check the dial is turned to
z
before relighting. See 'Using the grill.'
Gas is leaking. See 'Leak testing.'
z
Why isn't grill getting hot on
Grill hasn't preheated enough. Preheat for full 10 minutes before cooking.
z
Grill is being affected by wind gusts. Move to a more sheltered area if possible.
z
LP gas cylinder is empty. Check cylinder, and get it refilled if empty.
z
A burner port is obstructed. See 'Cleaning the grill burners', 'Cleaning the sear burner'
z
or 'Cleaning the side burners.
'Flow Limiting Device is activated on LP cylinder. See 'Resetting flow limiting device.'
z
Why is there smoke coming from the grill?
Residue or grease on the grates or radiant trays. Brush residue off the grates with a grill
brush. Residue on radiant trays should burn off during the cook. See 'Cleaning.'

TROUBLESHOOTING

?
HI/SEAR
. See
SEAR/MAX
. Wait 5 minutes
OFF
39