Troubleshooting - DCS BE1-48R Installation Manual

Before calling for service
If the grill does not function properly, use the following checklist before contacting your dealer for
service. You may save the cost of a service call. Troubleshooting is for general purposes only. If the
problem persists and you feel you require service, contact your dealer or the nearest authorized
agency to perform service. Only authorized agencies can perform warranty service. Contact DCS at
www.dcsappliances.com
PROBLEM
Grill won't light when the
control knob is pushed
Low heat with knob in "HI/
SEAR" position
Burner flame is yellow or
orange in conjunction with
the odor of gas
Rotisserie wont hold flame
once button is released
Dial lights and grill lights
don't turn on
Internal light not working
44

TROUBLESHOOTING

POSSIBLE CAUSES
Gas supply is turned off
Power supply is off
Grill may be in a dusty area
If using LP gas, tank may be
empty
If only one burner is low, a port
may
be obstructed
Gas supply is turned off
Power supply is off
Power supply is off
GFI has tripped (Ground Fault
Interrupter)
Transformer fuse has blown
Bulb has blown
WHAT TO DO
Check gas supply,
Check that the grill is
connected to a live AC
power source
Check GFI outlet, reset if
tripped
Check power supply fuse,
replace if blown
Move to a less dusty area if
possible
Check gas supply
See page 41 for instructions
on cleaning the orifice and
burner
Preheat grill for a full 15
minutes
Check gas supply
Check that the grill is
connected to a live AC
power source
Check GFI outlet, reset if
tripped
Check power supply fuse,
replace if blown
See page 36 for instructions
on manually lighting the
rotisserie
Continue holding safety
valve button in depressed
position until burner remains
lit when released
Check that the grill is
connected to a live AC
power source
Check GFI outlet, reset if
tripped
Check power supply fuse,
replace if blown
Remove glass lens, replace
with 12v G4 halogen bulb