Husqvarna P 524XR EFI Operator's Manual page 56

8. Loosen the locknuts on the height adjustment stay.
Turn the clevis joint to adjust the length of the height
adjustment stay. Align the clevis joint with the hole
on the frame of the cutting deck. Install the clevis
joint to the frame of the cutting deck.
9. Do a test of all of the cutting heights. Refer to
adjust the cutting height (C112, C122, R137) on
page 32 .
10. Tighten the locknuts on the height adjustment stay.
11. Install the front cover.
To adjust the parallelism of the cutting
deck (C112X, C122X, R137X)
Adjust the parallelism when the cutting deck is installed
on the product.
1. Remove the clevis joint on the rear end of the
electric actuator from the frame of the cutting deck.
56
2. Push the switch for the electric lift to lower the
cutting deck. Lower the cutting deck fully until you
hear a pattering sound.
To
Note:
does not mean that the product is damaged.
3. Loosen the locknuts on the lift stay.
4. Turn the adjustment nut on the lift stay to adjust the
length of the lift stay. Increase the length to lift the
rear edge of the cover. Decrease the length to lower
the rear edge of the cover.
CAUTION:
Hold the switch a
minimum of 2 seconds after the cutting
deck touches the ground. This is to
make sure that the cutting deck is in float
position.
The pattering sound from the frame tunnel
1929 - 003 - 05.12.2023