Husqvarna P 524XR EFI Operator's Manual page 75

Problem
The remote control is set to
ON but the control functions
are off. There is no radio
communication between the
product and the remote con-
trol.
The remote control is set to
ON but the control functions
are off. The radio signal is in
standby mode.
The remote control is on but
some of the control functions
are off.
The information center dis-
play becomes red and shows
an error code.
The information center dis-
play shows the symbol that
follows.
1.
1929 - 003 - 05.12.2023
Cause
Incorrect start procedure of the remote
control mode.
The remote control is not in correct opera-
tion range.
No radio communication between the re-
mote control and the product because of
radio communication interference.
No pairing operation between the product
and the remote control has been made.
The switch for remote control mode is
damaged or does not operate correctly.
Incorrect start procedure of the remote
control mode.
Incorrect start procedure of the remote
control mode.
Damaged controls or switches on the re-
mote control.
The controls or switches on the remote
control are not correctly connected.
An error has occurred.
The test mode has been started.
Solution
Put the remote control to OFF and
stop the product. Restart the product
and the remote control after 5 seconds.
Start the remote control mode, refer
To start the remote control mode
to
on page 37 . Speak to your Husqvarna
servicing dealer if the problem contin-
ues.
Make sure that the remote control is
in the correct operation range. Refer to
Technical data on page 82 and Work
area safety in remote control mode on
page 21 .
Stop all other radio communication
equipment that can cause interference.
Speak to your Husqvarna servicing
dealer if a new pairing operation is nec-
essary.
Disconnect the wire for the remote con-
trol mode actuator. Refer to
nect the cable for the remote control
mode actuator on page 69 .
Speak to your Husqvarna servicing
dealer if if the switch for the remote
control mode is damaged or does not
operate correctly.
Make sure that all controls and
switches are in neutral position when
the remote control is started.
Disengage the machine stop button on
the remote control.
Make sure that all controls and
switches are in neutral position when
you start the remote control.
Speak to your Husqvarna servicing
dealer.
Error codes and descriptions
Refer to
on page 77 .
Restart the remote control to exit the
test mode. The test mode is only a
diagnostic tool for the servicing of the
product.
Speak to your Husqvarna servicing
dealer.
To discon-
75