Troubleshooting - Husqvarna Z572X Operator's Manual

To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
Tightening torques
Engine crankshaft bolt
Mandrel pulley nuts
Idler pulley nuts
Idler arm bushing nut
Lug nuts
Blade bolts
Spark plug
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
26
2. Lubricate the 3 cutting deck spindles (B) 2-3
3. Lubricate the idler arm (C) 2-3 strokes.
A
C
B
50 ft-lb / 68 Nm
17 ft-lb / 23 Nm
30 ft-lb / 40.6 Nm
70 ft-lb / 95 Nm
75 ft-lb / 102 Nm
90 ft-lb / 122 Nm
16.6 ft-lb / 22.5 Nm

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 5 .
Steering controls are not locked in the parking brake position.
The battery is too weak. Refer to
20 .
There is dirt in the carburetor or fuel line.
The shut-off valve of fuel supply is closed or in incorrect posi-
tion.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
To charge the battery on page
PTO (Power Take-
2171 - 001 - 14.06.2023