Husqvarna P 524XR EFI Operator's Manual page 53

15. Pull the drive belt out.
16. Attach a new drive belt in the opposite sequence.
Make sure that the drive belt for the cutting deck is
attached as the illustration shows. Make sure that it is
put correctly in the adjuster pulley, identified by an arrow
in the illustration.
To put the cutting deck in servicing
position
WARNING:
body parts away.
1. Pull the switch for the electric lift to lift the cutting
deck. Lift the cutting deck fully until you hear a
pattering sound.
1929 - 003 - 05.12.2023
Risk of crush injury, keep
Note:
The pattering sound from the frame tunnel
does not mean that the product is defective.
2. Release the clip on the front cover with the tool
attached to the ignition key, and remove the cover.
3. Set the cutting height to the lowest position. Refer
To adjust the cutting height (C112, C122, R137)
to
on page 32 or To adjust the cutting height (C112X,
C122X, R137X) on page 33 .
4. Pull the spring handle to the left out from the spring
holder to loosen the tension on the tension wheel for
the drive belt.
5. Remove the belt from the pulley on the tool frame.
53