Husqvarna P 524XR EFI Operator's Manual page 54

6. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
7. Lift the cutting deck to vertical position until a
click sound is heard. The cutting deck is locked
automatically in the vertical position.
To put the cutting deck in mow position
1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Lower the cutting deck and push it in until it stops.
CAUTION:
models C112X, C122X, R137X: Make
sure that the the cable to the cutting
deck does not get compressed.
4. Put the drive belt around the drive wheel for the
cutting deck.
54
For the cutting deck
5. Put the spring handle in the spring holder.
6. Install the front cover.
To examine and adjust the ground
pressure from the cutting deck
A correct ground pressure makes sure that the cutting
deck moves along the surface but does not press too
hard against it.
1. Do a check of the air pressure in the tires. Refer to
Tire pressure on page 51 .
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Put a bathroom scale below the front edge of the
cutting deck.
5. Put a wooden block between the frame and the
bathroom scale. The wooden block makes sure that
no weight is applied on the support wheels.
6. To adjust the ground pressure, turn the adjustment
screws found behind the front wheels on the right
and left sides.
1929 - 003 - 05.12.2023