Husqvarna P 524XR EFI Operator's Manual page 30

• To adjust the seat springs, move the rubber stops
below the seat as given in the illustration. Put the 2
stops in the front, middle or rear.
To lift the cutting deck
1. Push the PTO button to disengage the drive of the
cutting deck.
2. Pull the switch for the electric lift to lift the cutting
deck. Lift the cutting deck fully until you hear a
pattering sound.
Note:
The pattering sound from the frame tunnel does
not mean that the product is defective.
Note:
You can lift the cutting deck a small distance
with the drive on the blades engaged. Use this function
for very long grass or rough surfaces.
WARNING:
fully while the drive of the cutting deck is
engaged. There is a risk of thrown objects
that can cause serious injury or death.
30
Do not lift the cutting deck
To lower the cutting deck
1. Push the switch for the electric lift to lower the
cutting deck. Lower the cutting deck fully until you
hear a pattering sound.
CAUTION:
minimum of 2 seconds after the cutting
deck touches the ground. This is to
make sure that the cutting deck is in float
position.
Note:
The pattering sound from the frame tunnel
does not mean that the product is defective.
2. Pull the PTO button to engage the drive on the
cutting deck blades.
To do before you operate the product
WARNING:
with the remote control if you do not have
a clear view of the product. The operation
range of the remote control makes it
possible to move the product also when you
cannot see it. Risk of injury and damage.
WARNING:
distance when you operate the product
with the remote control. Refer to
data on page 82 . The product stops
automatically when the product is out of
range of the remote control. This can cause
dangerous situations.
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Put on necessary personal protective equipment.
Personal protective equipment on page 14 .
Refer to
Hold the switch a
Do not operate the product
Stay in the operation
Technical
1929 - 003 - 05.12.2023