Husqvarna P 524XR EFI Operator's Manual page 37

• Learn how to use the controls before you operate the
product in your direction. The controls on the remote
control are in relation to the direction of movement
of the product. The product turns in relation to the
direction of movement seen from the point of view of
the product. The illustration below shows an operator
that turns left in relation to the product.
To start the remote control mode
1. Push the PTO button on the product.
2. Put the ignition key in neutral position.
3. Release the parking brake on the product. Refer to
To apply and release the parking brake on page 34 .
4. Remove the remote control from the remote control
storage box.
5. Put on the remote control harness when you operate
the product with the remote control. Refer to
the remote control harness on page 36 .
1929 - 003 - 05.12.2023
6. Put the switch for remote control mode on the
product to the "1" position.
Note:
in position "1" after less than 3 minutes after the
ignition key has been put in neutral position. After 3
minutes, it is necessary to turn the ignition key to the
STOP position and try again.
7. Step out of the work area with the remote control.
8. Turn the machine stop button on the remote control
clockwise to make sure that the machine stop button
is disengaged.
9. Push the ON/OFF button on the remote control to
start the remote control.
To use
The switch for the remote control must be
37