Husqvarna P 524XR EFI Operator's Manual page 41

To lift and lower the cutting deck with the
remote control
1. Push and hold the button (A) to lift the cutting deck.
Release the button (A) when the cutting deck is in
correct position.
A
B
2. Push and hold the button (B) to lower the cutting
deck. Release the button (B) when the cutting deck
is in correct position.
CAUTION:
of 2 seconds after the cutting deck touches
the ground. This is to make sure that the
cutting deck is in float position.
Note:
The pattering sound from the frame tunnel does
not mean that the product is damaged or do not operate
correctly.
To use the boost function
The remote control has a boost function that increases
the transmission power of the product, which increases
the operation speed. Use the boost function on a steep
slope, to move the product out of an obstacle or hole, or
to move the product between areas that you do not cut.
WARNING:
button when you turn the product. Too fast
operation speed can cause the product to
skid or fall.
1929 - 003 - 05.12.2023
Hold the button a minimum
Do not push the boost
1. Push and hold the boost button to use the boost
function.
Note:
The boost button indicator comes on when
you push the boost button.
2. Release the boost button to stop the boost function.
Note:
When the boost button and the drive control
are released the product will stop in less than 2
seconds.
Note:
The product will automatically stop when
you do the following on the remote control:
• Push the engine stop/start switch to the left.
• Push the ON/OFF button.
• Push the machine stop button.
WARNING:
push the machine stop button in a
slope. The angle of the slope can cause
unwanted movement down the slope.
To stop the engine with the remote control
1. Release the control for forward or reverse operation
(A) and the steering control (B).
A
E
Be careful when you
B
C
D
41