Table of Contents
Advertisement
9.3 The drying cycle is long and the washing is still humid.
Has the washing been through a
sufficient spin cycle, or is the load
quantity appropriate?
Y
E
S
Are the fluff filters clean and is the
condensation water tank empty?
Y
E
S
Does the compressor start a few
minutes after the programme has
started without any alarm being
triggered?
Y
E
S
Check the performance of the
compressor comparing the
temperature data shown in the
service manual.
Is the compressor performance data
the same as that specified?
Y
E
S
Appliance OK, run the diagnostics
programme.
Technical Support - A.D.L.
Spin the washing before placing it
inside the tumble dryer and check the
NO
load quantity.
Clean all the filters and empty out the
NO
Check for any alarms and remedy
NO
them according to the alarms table.
Replace the complete base or
recharge the closed gas circuit.
NO
64/69
condensation water tank.
R134a 270g
599 76 86-51 Rev. 01
Advertisement
Table of Contents
