Electrolux 599 76 86-51 Service Manual page 55

E51 Motor power triac short-circuited
E52 Motor thermal cut-out triggered.
E53 Motor TRIAC "sensing" circuit faulty
E54 Motor blocked.
E55 Inverter board safety alarm
Inverter is drawing too much current
E57
(>15A)
Inverter is drawing too much current
E58
(>4.5A)
No signal from tachometric generator
E59
for 3 seconds
Technical Support - A.D.L.
Full name
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended
 If it is detected before the cycle starts, the cycle
start will not be permitted.
Action
55/69
Notes and possible causes
 Motor faulty.
 Faulty wiring.
 Main circuit board faulty.
 Motor faulty.
 Motor thermal cut-out has triggered.
 Faulty wiring.
 Main circuit board faulty.
 Main circuit board faulty.
 Washing load is too large.
 Power supply voltage low.
 Motor/drive system blocked.
----------------
 Motor-inverter wiring faulty.
 Inverter board faulty.
 Motor faulty.
 Abnormal motor operation (overload).
 Motor-inverter wiring faulty.
 Motor faulty.
 Inverter board faulty.
 Motor-inverter wiring faulty.
 Inverter board faulty.
 Motor faulty.
599 76 86-51 Rev. 01