Troubleshooting; The Machine Will Not Start; Overheating Cut-Out; Drying Takes Too Long - Electrolux TW SL3 M100 Operating Instruction

Troubleshooting

The machine will not start

Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. To cancel Delayed Start, press the
Stop button for three seconds.
• that the plug is connected.
• that the main fuses have not blown.
• that the overheating cut-out has not been
triggered.

Overheating cut-out

The overheating cut-out shuts off the tumble dryer
if the temperature is too high, e.g. because dust
is clogging the lint filter.
• Clean the lint filter.
• The overheating cut-out will reset automatically
once the machine has cooled down.
18

Drying takes too long

• Check that the lint filter is not blocked. See the
"Care and cleaning" chapter.
• Empty the condensed water container and
check that the steamer filter and steamer are
not blocked. See the "Care and cleaning"
chapter.

Error messages

• If Over Flow appears on the display, the
condensed water container is full or the
steamer filter is blocked. Empty the container,
clean the filter and restart the machine. See
the "Care and cleaning" chapter.
• Read "Drying takes too long" in this chapter if
"Max program time " appears on the display.
• If "" appears on the display, clean the lint filter.
• If "Clean condenser" appears on the display,
clean the steamer. See the "Care and cleaning"
chapter.
• If "Clean auto filter" appears on the display,
clean the water filter. See the "Care and
cleaning" chapter.
• Press the Stop button to close any error
messages.