Nominal Width 625 - 800 - Bracket Iii; Manhole Rings (To Din 4034-1 And 2) With An Overall Height Of 250 Mm - probst SVZ-UNI-VARIO Operating Instructions Manual

Operation
Nominal width 625 - 800 – Bracket III
All three stabilizers of the device must always rest on the upper edge of the gripping good
(manhole/cone)! (see Fig. 4)
As soon as only one of the three stabilizers has a larger distance than 15 mm (between stabilizer
lower edge and gripping good upper edge), it is in no case allowed, to lifted the gripping good !
TIP: Lower the device to the ground and try again.
Otherwise it exists slipping danger of the gripping good!
Upper bracket
(Bracket II)
Lower edge of
upper bracket
Lift the support frame slowly with gripped gripping good and avoid jerky movements!
Never drive with the support frame (excavator) and gripped-load on device
(SVZ-UNI) over uneven area faster than slow walking speed!
6.2.1.1

Manhole rings (to DIN 4034-1 and 2) with an overall height of 250 mm

When gripping shaft rings with a minimum height of 250 mm, the following
accessory must also be fitted: "Adapter set for SVZ-UNI support" (see
adjacent illustration).
Order no.: 44000079
Adapter set may only be used if shaft rings with installation height 250 mm
are to be offset (and not generally for greater installation heights)!
Manhole rings with a height of less than 250 mm must not be gripped
and transported!
Gripping manhole rings (construction height 250 mm) WITHOUT the above-mentioned
accessory (44000079) is prohibited (→ see Fig. 1).
Risk of slipping and risk of damage to the material to be gripped!
54000041
Fig. 4
→
22 / 33
Upper
edege of
gripping
good
Gripping good
(manhole)
GB