Assembly and adjustments
3.1.1 Adjustment screeding width TAAS-UNI-450
When adjusting the maximum screeding width (X2) of 4500 mm, a minimum overlap (X1) of the
individual screeding profiles of 331 mm is permissible (→ Fig. 1).
The overlap of the individual screeding profiles must be chosen to be approximately the same width at
each point.
The eyebolts must both be in the overlap area of the overlapped screeding profiles (in the area of
dimension X). The clipped connection should be positioned approximately centrally in the overlap area.
Fig. 1
51000100 / 51000101
X = Overlap area
X1 = overlap peel-off profiles
X2 =maximum permissible screeding width
9 / 19
GB