Environmental Specifications; Space Requirements - Xerox DocuPrint 92C Installation Planning Manual

Environmental specifications

Space requirements

Printer controller placement
XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE
Heat dissipation specifications for the DocuPrint Model 92C IPS
controller are shown in the table below.
For recommended environmental ranges for the printer work area,
refer to the "Printer specifications and requirements" chapter of this
guide.
Table 5-3. Heat dissipation specifications for the
DocuPrint Model 92C IPS controller
Heat dissipation
Processor/monitor 1,100 BTU per hour
HCU
The printer controller consists of the Sun workstation and, for
channel-attached systems, the HCU. This section provides
recommendations for placement of controller hardware components.
For printer component space requirements, refer to the "Printer
specifications and requirements" chapter of this guide. Contact your
service representative if you have questions not specifically
addressed in this guide.
You should consider the following factors when deciding where to
place the DocuPrint printer controller:
•
Adequate work space and service clearance around the
equipment
•
Proximity to electrical and network connectors
•
Security of the work area. You may need to place the system in
an area where you can restrict access to it.
The printer controller consists of the Sun workstation and, for
channel-attached systems, the HCU. You must supply a table or
desk as a work surface for both the printer controller and the HCU.
The top of the table must provide at least 36 by 36 inches / 91 by 91
cm of space for each component, to allow enough space for the
components and cables, as well as for service access.
Refer to the "DocuPrint Model 92C IPS printer controller
specifications and power requirements" summary table at the end of
this chapter to make sure the tables you supply can support the
weight of the printer controller hardware elements and of the HCU,
and that they are suitable for the intended use.
Warning: The printer controller must be positioned within the line-
!
of-sight of the printer for safety purposes while servicing the
equipment.
!
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
408 BTU per hour
5-3