Xerox DocuPrint 92C Installation Planning Manual page 118

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Item
description Default
MARK NO
MODE FSS (if FSS=
is coded)
PRESELECT YES
ROUTECDE None
START YES
TRKCELL no
WS None
FSS (FSS1)
PRT0001
Configuring in JES3
E-4
Table E-1.JES2 FSS statement parameters (continued)
Range of
acceptable
Source of value values
Installation YES or NO
preferences
Must be FSS FSS
Installation YES or NO
preferences
Installation printer 1 to 4 destination
name standards names
Should be NO for YES or NO
TCP/IP printers.
See JES2 YES or NO
SPOOLDEF
statement
Installation See JES2
preferences Initialization and
Tuning Manual.
Following is an example of the JES2 Initialization Dataset
required commands:
Table E-2.JES2 Initialization Dataset commands example
PROC=FSSPROC1,HASPFSSM=HASPFSSM,AUTOSTOP=YES
CLASS=E,FSS=FSS1,MODE=FSS,PRESELCT=YES,
START-NO,TRKCELL=YES,WS=(Q)
Follow these steps to configure the PSF printer in JES3:
1. Locate the JES3 initialization dataset (commonly known as
Initialization Deck) in the JES3 catalogued JCL Procedure.
(This is normally kept in SYS1.PROCLIB, although your system
may use a different library.)
The JES3 PROC has a JES3IN DD statement, which points to
the initialization dataset. The default initialization deck is in
SYS1.SAMPLIB (member JES3IN00); however, you should
verify your location by looking at the JES3 procedure.
2. Enter the following required commands in the JES3 initialization
deck to define the PSF functional subsystem (FSS):
Comments
YES specifies for IPS
that there is either
offsetting or stitching of
jobs, subject to value of
COPYMARK parameter
and setting on IPS.
MODE=FSS should be
specified.
Specifies whether
output datasets are
preselected for this
FSA.
If WS if F, only output
with these destinations
is selected for this
printer.
START=NO should be
specified so TCP/IP can
be started before the
FSS.
IBM recommends YES.
Consider CL, R, and F.
See JES2 Initialization
and Tuning Manual for
more information.
XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE
Your value