Installation; Installation Process - Xerox DocuPrint 92C Installation Planning Manual

Installation process

XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE
8.
This chapter describes the activities performed by you and Xerox
during the installation of the Xerox DocuPrint Model 92C IPS
hardware and software components. Before installation can begin,
you must complete the tasks described in the "Preparing for
installation" chapter of this guide.
Xerox is responsible for the physical installation of the DocuPrint
Model 92C IPS hardware components and the software.
For customers outside the United States, contact your local Xerox
representative or operating company for your specific installation
process.
The installation process can take one or several days to complete.
Equipment, software kits, and documentation kits may all arrive in
one day, or over the course of several days. When all of the
necessary items are in place, Xerox personnel will complete the
installation of the IPS components.
The steps in the installation process typically occur in the following
order:
1. Xerox personnel install all IPS hardware and options at your
site. This process takes approximately 24 hours if all of the
necessary connectors are in place.
2. Xerox personnel place the system online.
3. Xerox personnel load the initial applications and run sample
jobs.
4. Xerox personnel test the system and run sample jobs (30
minutes).
5. Xerox personnel conduct initial operations training (2 to 4
hours).
6. Xerox personnel review preventive maintenance schedules and
service call procedures.

8Installation

8-1