Xerox DocuPrint 92C Installation Planning Manual page 70

PRINTER SPECIFICATIONS AND REQUIREMENTS
Using the turning radius table
6-16
Figure 6-9. T-shaped turn
1 Passage A
2 Passage B
Figure 6-10. L-shaped turn
1 Passage A
2 Passage B
To use the following table:
1. Measure the minimum width of the passage or doorway you
need to use. This is Passage A.
2. Find that number (or the next higher number) in the turning
radius table and read across to the corresponding minimum
value for Passage B, depending on the type of turn the
equipment must negotiate.
XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE