Specifications
Performance Specifications
Feature
Description
Press Warmup Time
The press warmup times vary depending on the current state / mode
of the press. Warmup times are listed as follows:
• From a cold start (either power on or power saver mode), less than
• From Sleep Mode / Power Saver, less than 5 minutes
• From Standby Mode, less than 1 minute
• When switching print modes (such as from black only to full color),
Time of First Print Out of
This is the minimum time from when the press receives a job from
Press
the print server to the time when the trail edge of the first print passes
through the press exit sensor.
• From a cold start (power on or power saver), the system takes less
• From standby mode, the system usually takes less than 1 minute
Environmental Specifications
The press enters the Power Saver mode after fifteen minutes of inactivity. The factory
default time of fifteen minutes can be changed when logged on as the administrator.
For more information, refer to the System Administration Guide.
The temperature and relative humidity of the room where the press is located must be
within the minimum and maximum allowable temperature and relative humidity limits
for the press system to operate correctly.
Operating Environment
Required Temperature Range
Required Relative Humidity
Altitude(above sea level)
Sound Pressure Levels
8-2
5 minutes
approximately 2 minutes
than 5 minutes to start printing
to the start printing
Press
50° to 90° F (10° to 32° C)
15% to 85% Relative Humidity (RH)
Max of 8,200 ft. (2,500 meters)
• Running: 65 dBA (decibels (Acoustics))
• Standby: 40.8 dBA
®
®
Xerox
Versant
3100 Press
User Guide