Xerox DocuPrint 92C Installation Planning Manual page 120

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Item
description Default
DGROUP None
DTYPE None
DYNAMIC NO
FSSNAME None
JNAME None
JUNIT ON
MODE None
WC Any class
selected
WS
E-6
Table E-3.JES3 FSS statement parameters (continued)
Range of
acceptable
Source of value values
Installation 1 to 8-character
printer alphanumeric
destination string
naming
conventions
PRTAFP1 PRTAFP1
Installation YES or NO
printer name
standards
Name of FSA in 1 to 8-character
JNAME alphanumeric
parameter string
FSSNAME 1 to 8-character
parameter of alphanumeric
FSSDEF string
statement
See comments. (Device address,
Main, dest class,
ON/OFF)
Must be FSS. FSS
Installation List of
output class alphanumeric
standards output classes,
each separated
by a comma
Installation Work-selection
preferences (see criterion
note)
Note: The WS parameter CL specifies that datasets with the
same class as the WS parameter should be selected. D
specifies that only datasets with the same destination as the
DGROUP parameter should be selected. F specifies that JES3
Comments
Specifies destination
processed by this FSA
(applicable only if D is
specified in the WS
parameter).
Required parameter
DYNAMIC=NO should be
specified so JES3 will
keep FSA active between
transmission of datasets.
Must match value in
FSSNAME parameter of
FSSDEF statement.
Must match value in
FSSNAME parameter of
FSSDEF statement.
Device address should not
be specified for TCP/IP
printers.
Main is name of processor
the FSS is to run on.
Dest class is destination
class for FSA messages.
ON or OFF specifies
whether FSA is initially
online or offline.
MODE=FSS must be
specified.
If CLASS is specified in
the Work-selection
criterion in the WS
parameter, the FSA
selects datasets that
match values specified
here.
Consider CL, R, and F.
See Note below and JES3
Initialization and Tuning
Reference manual for
more information.
XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE
Your value