Xerox DocuPrint 92C Installation Planning Manual page 14

PRODUCT OVERVIEW
1-4
Jobs can also be printed on special stocks such as labels and
transparencies.
The printer engine monitors the print job so that, should a paper
jam occur, the job resumes on the correct page, providing
complete document integrity.
•
600 dpi resolution — The DocuPrint Model 92C IPS provides
high print quality at 600 dpi resolution. It can receive data at
240, 300 or 600 dpi; 240 and 300 dpi data is converted to 600
by the controller.
The IPS must be configured to the same font resolution as the
host input data stream (refer to your DocuPrint Model 92C IPS
Guide to Configuring and Managing the System for instructions
on configuring for the correct input resolution). Conflicts
between the input font resolution and the IPS configuration
could result in inability to print the job, or in variable data
missing from the output.
Note: You will normally achieve better print quality by
converting all 240 dpi fonts and other resources to 600 dpi
before printing, rather than leaving the conversion for the
controller to do. However, you should always run test prints to
validate your particular applications.
•
Bypass transport option — The bypass transport enables
sheets to pass through the printer output module to a third-party
finishing device. With such a device, you add to your DocuPrint
Model 92C IPS such finishing capabilities as saddle-stitching,
binding, trimming, etc. The bypass transport fits into tray 1 of
the dual stacker, and can be easily removed and installed by the
operator. (For further information on this option, refer to the
"Bypass transport specifications" appendix of this guide.)
•
Sixth Sense Remote Service — The Xerox Sixth Sense
Remote Service feature allows Xerox support personnel to
access IPS/NPS controller via modem from a remote location.
More information about Remote Service can be found in the
Xerox DocuPrint Model 92C IPS Troubleshooting Guide.
•
Choice of dual or stitcher stacker — Your DocuPrint Model
92C IPS is available with one of two stacker types: a dual
stacker, with two output trays, or a stitcher/stacker which can
place a wire stitch in sets of up to 50 sheets.
Output tray capacities, based on 20-pound or 80 gsm stock,
are:
— Dual stacker trays 1 and 2: 750 sheets each
— Stitcher/stacker: 2000 sheets.
XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE