Wireless Wan - Panasonic FZ-G2 Series Operating Instructions Manual

Wireless WAN

<Only for model with wireless WAN>
The model with wireless WAN allows for data communication using the incorporated communication module.
The computer is equipped with a nanoSIM card slot and an eSIM.
eSIM allows wireless communication without a nanoSIM card.
This model is DSSS (Dual SIM Single Standby) and you can only make either nanoSIM Card or eSIM Active.
l
I M P ORTANT
After performing recovery, reselect eSIM or nanoSIM card before using a wireless WAN.
l
When the eSIM is replaced due to repair, the computer is returned with an eSIM in default state. In this case, the customer
l
needs to download the profile again.
Some telecommunications carriers may allow you to continue the contract with no additional cost to use the remaining
capacity. For details, contact your telecommunications carrier. In doing so, it is recommended to put down the ICCID of
the profile beforehand.
When the wireless WAN module is replaced due to repair, it is necessary to configure the eSIM setting again.
l
<Only for model with wireless WAN (5G)>
l
Use a nanoSIM card or eSIM that supports 5G.
NOTE
Communication is established through the Wireless WAN antenna (A). Do not block the antenna area with your hand or
l
body.
<Only for model with wireless WAN (5G)>
<Only for model with wireless WAN (5G) / Only for mmWave service>
To use wireless WAN, set
l
[Wireless WAN] to [Enabled] (default) in the sub-menu of [Wireless Configuration] in the