Panasonic FZ-G2 Series Operating Instructions Manual page 160

Touchpad / Touchscreen
The pointer does not work.
<Only for model with Keyboard Base>
Cannot input using the touchpad.
Cannot point the correct position using the
pen (included) and fingers.
Smart Card (only for model with Smart Card slot)
Cannot use a Smart Card.
Barcode Reader (only for model with Barcode Reader)
Reading is not possible.
User Switching
Some applications do not work properly.
Others
Although the computer is turned on, the fol-
lowing problems is occurred.
The indicators does not light.
l
No sound.
l
Screen is dark.
l
No response.
Connect the external mouse correctly.
l
Restart the computer using the keyboard.
l
If the computer does not respond to keyboard commands, read
l
The touchpad may be disabled by some mouse drivers. Check your mouse's operating instruc-
l
tions.
The touchpad is disabled.
l
Press ≪ Fn≫ + ≪ Esc≫ to enable.
Perform the Calibrating the
l
Insert the Smart Card correctly.
l
To use a Smart Card, you need a specified software and driver.
l
Confirm that the barcode is readable (without damage, etc.). Confirm that the barcode (sym-
l
bology) is readable.
Confirm the area for reading. The distance from the reader to the barcode is important. As a
l
rule of thumb, a farther distance should be used for a larger symbol to allow the light to cover the
symbol. In addition, a closer distance should be used for a thinner symbol.
Be sure the barcode is not placed closer than necessary to the reader.
l
Confirm the assignment of [Barcode Reader Trigger] with the Setup Utility, and change the set-
l
ting if it is not assigned. (
When switching to a different user without signing out, some applications do not work properly.
l
In this case, sign out the other users.
Concealed mode is set to ON (
l
Open Task Manager and close the software application.
l
1. Right-click (Start) - [Task Manager].
An input screen (e.g., password input screen at startup) may be hidden behind another win-
l
dow. Use ≪ Alt≫ + ≪ Tab≫ to check.
Shut down by pressing and holding the power switch for 10 seconds or longer, and turn on the
l
computer and open the application again.
If Windows runs correctly, but the application software does not start, uninstall the failing applic-
l
ation software, then reinstall it.
To uninstall, perform the procedure below.
1. Right-click
(Start) - [Apps and Features] - [Apps & features].
2. Select the program you want to uninstall, and click [Uninstall].
Screen.
Tablet Button Configuration)
Concealed Mode).
"No response".