Panasonic FZ-G2 Series Operating Instructions Manual page 43

(Example)
Alternatively, you can check the remaining battery power by ≪ Fn≫ + ≪ F9≫ key combination. (After signing in to Windows)
(Example)
NOTE
The battery display may not correspond to the actual remaining battery power in the cases as below. To correct the dis-
l
play, perform the Battery Recalibration (
The battery indicator remains red.
l
The indicator lights orange and the display shows 99 % for a long time.
l
Low battery warning appears soon after a short time of use.
l
This can occur when the computer is in sleep for a long time without power supply from the AC adaptor.
The battery display may not be the same as that of task tray. This is not a malfunction.
l
Computer behavior with low battery
The default settings are as follows.
When the battery level becomes 10 %
[Low battery level]
Displays a message that the battery
l
level is low.
↓
Charge the battery.
Connect the AC adaptor imme-
l
diately. If you do not have the AC
adaptor, exit the running programs
and Windows, then confirm that the
power indicator is off.
If you have a fully charged spare bat-
l
tery, turn off the computer, replace
the battery and turn the computer on
again.
NOTE
Battery goes to hibernation if the battery level is about 5 %, may be displayed such as "Not exist" or "Not use" is not a mal-
l
function.
Please wait for a while to connect the AC adaptor.
Correcting the Battery Display (Battery Recalibration)
The "Battery Recalibration" function measures and memorizes the battery capacity. To correct the battery display, use this function to fill the battery and
then discharge it completely. Perform the procedure at least once immediately after purchasing the computer. Normally the interval of battery recal-
ibration is 3 months.
The battery display may not be correct when the battery pack deteriorates after a long time use. In this case, perform the procedure again.
Correcting the Battery Display (Battery
When the battery level becomes 5 %
The computer enters hibernation.
l
Connect the AC adaptor or replace the battery to start up the computer.
Connect the AC adaptor and charge the battery.
l
If you have a fully charged spare battery, turn off the computer, replace the battery and turn
l
the computer on again.
When the computer enters hibernation with the battery down and you resume the operation
without charging the battery, the Windows Resume Loader starts up. Follow the on-screen
instructions. After that, however, Windows may not start up normally, or the [Low battery
level]/[Critical battery level] function may not work normally.
Recalibration)).
[Critical battery level]
↓