Panasonic FZ-G2 Series Operating Instructions Manual page 165

l
You can check the status and results of the diagnostic check via the progress bar displayed on the right of the hardware icon.
l
When the bar is progressing: The diagnostic check is in progress.
l
During memory diagnostic check, the display may stop for a long period of time. Wait until the process is complete.
When the bar is green: No problems discovered.
l
When the bar is red: Problems discovered.
l
When the bar is yellow: The diagnostic check has been stopped or canceled.
l
NOTE
Using the following procedure, you can run a diagnostic check on a specified hardware component, or run an
l
extended diagnostic check (The extended diagnostic check is only specified). The extended diagnostic check is
more detailed, and so requires a longer period of time to run.
1. Click
l
l
l
2. Click
l
7. When all the hardware check is complete, confirm the diagnostic check results.
If the display is red and the message "TEST FAILED" is displayed, you can assume that there is a problem with the computer's hardware. Con-
firm which hardware component is displayed as red, and contact Panasonic Technical Support.
If the display is green and the message "TEST PASSED" is displayed, the computer's hardware is operating normally. Continue using the com-
puter as it is. If the computer still does not operate properly, reinstall the software (
8. After the diagnostic check is complete, click
When the Icon Becomes Gray and the Corresponding Device Cannot Be Checked
The device is disabled in the Setup Utility:
l
Set the device to [Enabled] in the Setup Utility.
: Display help (click the screen or press ≪ Space≫ to return to the original screen).
to stop the diagnostic check, and click the hardware icon to configure the diagnostic.
Standard display (B): Perform diagnostic check.
"Full" display (C): Perform extended diagnostic check. ("Storage", "Keyboard" and "Touch Screen" only)
Gray display (D): Do not perform diagnostic check.
to start the diagnostic check.
Display during diagnostic check (E): Diagnostic check is in progress.
Installing
(close), or press ≪ Ctrl≫ + ≪ Alt≫ + ≪ Del≫ to restart the computer.
Software).