Panasonic FZ-G2 Series Operating Instructions Manual page 158

Access point is not detected.
<Only for model with wireless WAN>
Cannot communicate.
Display Rotation
Cannot rotate the display.
The operations of screen do not match the
rotation angle.
Connecting Peripherals
An error occurs when installing the driver.
A peripheral device does not work.
The connected mouse does not work.
You do not know the address map for IRQ,
I/O port address, etc.
Shorten the distance between the computer and the access point, and try the detection again.
l
Confirm the following settings:
l
[Wireless LAN]
l
Confirm that
l
Check the channel being used by the access point.
l
Confirm the following settings:
l
[Wireless WAN]
l
Confirm that [Wireless WAN] of [Wireless Configuration] is set to [Enabled].
l
Confirm that the nanoSIM card is inserted correctly.
l
If you cannot be connected to the network after inserting the nanoSIM card, confirm
l
anoSIM Switching".
If communication is not established after proceeding with the above remedies, the wireless WAN device
may not be correctly recognized. Restart the computer.
The application program currently running may not support the image rotation. Quit the pro-
l
gram, and then try to rotate the image. This can ameliorate the status.
When the automatic rotation is off, screen display does not rotate automatically.
l
The application program currently running may not support the image rotation. Quit the pro-
l
gram, and then try to rotate the image. This can ameliorate the status. Change a screen setup
to landscape.
When you install a driver of card or peripheral device, make sure that the driver is compatible
l
with the operating system. If it is not compatible, malfunction may occur. For information about
the driver, contact the manufacturer of the peripheral device.
Install the driver.
l
Contact the manufacturer of the device.
l
When operation resumes from sleep or hibernation, devices such as an external mouse and
l
cards may not function properly. In this case, restart the computer or reinitialize the device.
When is displayed in the Device Manager, remove and insert the device. If the problem
l
persists, restart the computer.
The settings of USB ports can be changed separately for the computer and the cradle
l
(optional). In the [Advanced] menu of the Setup Utility, check both
board Base and Cradle USB Port]
The computer may not recognize the connection/removal of some devices, or may not operate
l
normally with some devices.
1. Right-click
2. Select the device, and remove the check mark for [Allow the computer to turn off this
device to save power] in [Power Management]. (This item may be unavailable for
some types of devices.)
In the case that a USB device does not work, remove the USB device and connect it again or
l
connect the USB device to another port.
Depending on the peripheral devices, it may not operate normally when connected to the USB
l
port with the continuous power supply function.
Check the mouse connection.
l
Install the driver compatible with the connected mouse.
l
You can check with the following procedure.
l
1. Right-click
2. Click [View] - [Resources by type].
in the [Advanced] menu of the Setup Utility
[Wireless LAN] of [Wireless Configuration] is set to [Enabled].
in the [Advanced] menu of the Setup Utility
settings.
(Start) - [Device Manager].
(Start) - [Device Manager].
"eSIM/n-
[Tablet USB Port] and [Key-