Maintenance - Panasonic FZ-G2 Series Operating Instructions Manual

If screws are included, fasten them securely.
l
Remove the cables when you carry the computer. Do not pull the cables forcibly.
l
Preventing your computer from unauthorized use via wireless LAN/Bluetooth/wireless WAN
<Only for model with wireless LAN/Bluetooth/wireless WAN>
Before using wireless LAN/Bluetooth/wireless WAN, make the appropriate security settings such as data encryption.
l
When the battery indicator does not light on
The battery indicator may not light on even if the AC adaptor and the battery pack are correctly connected to the computer, due to the following reasons.
The AC adaptor's protection function may be working. In this case, pull out the AC cord and wait for more than 1 minute before reconnecting the
l
AC cord.
Sensors
This computer is equipped with four sensors (acceleration sensor, gyro sensor, magnetic sensor, ambient light sensor), and you can use these sensors
with any software that is compatible.
As the accuracy of each sensor output is dependent on the operating environment and other conditions, the results should only be used as a reference.
The acceleration sensor, gyro sensor, and magnetic sensor are located at the bottom left of the LCD. The detection results of each sensor may vary
depending on how you are holding the computer, the application software you are using, and other factors.
Magnetic sensor
The magnetic sensor on the computer operates by detecting geomagnetism. Therefore, the magnetic sensor may not function properly and it readings
may be inaccurate, especially in the following environments.
Inside or near steel structures such as buildings or bridges
l
Inside or near automobiles, or near train power lines
l
Near metallic furniture or appliances
l
When the AC adaptor or other peripheral devices are brought closer to the computer
l
Near magnets, speakers, or other objects with strong magnetic fields
l
The magnetic directions indicated by the magnetic sensor may not be accurate immediately after purchase or in environments with poor magnetic fields.
In such cases, turn on the computer and move it as follows.
1. Hold the computer so that its screen side is facing upward and level.
2. While keeping the computer level, rotate it 90 degrees or more clockwise.
3. Return the computer to position 1, and rotate it 90 degrees or more counterclockwise.
4. Return the computer to position 1.
5. Tilt the computer 90 degrees or more to the left so that the left side of the computer tilts down.
6. Return the computer to position 1, and tilt it 90 degrees or more to the right so that the right side of the computer tilts down.
I M P ORTANT
Hold the computer firmly when moving it. Strong shocks from dropping the computer may result in damage.
l

Maintenance

If drops of water or other stains get on the surface of the LCD panel, wipe them off immediately. Failure to do so may result in staining.
Cleaning the LCD panel
The screen is specially treated to prevent dirt from adhering to the surface. Also, to improve the outdoor visibility of the display, a low reflection coating has
been added.
When removing the dirt on the screen surface, use only an approved soft cloth (included) in order to avoid scratches and peeling of the coating.
Before using the computer, be sure to read the instructions provided below.