DEBIX Infinity User Manual page 38

motherboard will flash quickly, please wait. When the green LED changes from fast flash
to slow flash, that is, the programming is complete.
IMPORTANT
If the system with the same version as the Micro SD card has been burned to eMMC, the
system will not be burned again, and the indicator light will not flash quickly.
If you need to flash the eMMC system again, you need to format the eMMC first. Proceed
as follows:
1) Connect the motherboard to the keyboard, mouse and HDMI display, set the DIP
switch to "11" to start the system from the Micro SD card, and power on.
2) In the Terminal, enter the default username "debix" and password "debix" to enter the
command line, and run the following commands (as shown in the figure below):
#sudo su (password: debix)
#fdisk /dev/mmcblk2
d
d
w
3) Repeat step 2 to burn the system to eMMC again.
www.debix.io
Polyhex Technology Company Limited
Figure 33
38 / 79