Conductivity; Measuring; Calibration; General Information - Xylem wtw MIQ/IDS Operating Manual

MIQ/IDS
Prerequisites
Making the

settings

ba77277d01
7

Conductivity

The MIQ/IDS module connects IDS sensors to the IQ S
Suitable sensors: see section 7.5 A
7.1

Measuring

CAUTION
Contact with the sample can lead to danger to the user!
Depending on the type of sample, suitable protective mea-
sures must be taken (protective clothing, protective goggles,
etc.).
 The IQ S
ENSOR
(see IQ S
ENSOR
 The sensor is connected to the MIQ/IDS module
(see section 3.7).
1. Install the sensor in a flow through armature and provide the sample flow.
or
Submerse the sensor in the sample.
7.2

Calibration

7.2.1 General information

Normally, the conductivity measuring cell does not age. Special measuring
media (e.g. strong acids and bases, organic solvents) or temperatures that are
too high may considerably reduce its lifetime or lead to damage.
The cell constant can be calibrated on an IDS meter (see operating
manual of the meter).
7.3 Settings
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu of the sensor. The procedure is
described in detail in the IQ S
01/2024
CCESSORIES
N system is in operation
ET
N system operating manual).
ET
N
ENSOR ET
ENSOR
system operating manual.
Conductivity
N .
ET
39