MIQ/IDS
Prerequisites
ba77277d01
01/2024
4
pH
The MIQ/IDS module connects IDS sensors to the IQ S
Suitable sensors: see section 4.5 A
4.1
Measuring
CAUTION
Contact with the sample can lead to danger to the user!
Depending on the type of sample, suitable protective mea-
sures must be taken (protective clothing, protective goggles,
etc.).
Calibrate the sensor at regular intervals (depending on the applica-
tion).
The IQ S
N
ENSOR
(see IQ S
N
ENSOR
The sensor is connected to the MIQ/IDS module
(see section 3.7).
1.
Install the sensor in a flow through armature and provide the sample flow.
or
Submerse the sensor in the sample.
4.2
Calibration
4.2.1 General information on calibration
Calibration can be carried out on the following devices:
on the IQ S
(see section 4.2.2 C
IQ S
ENSOR
on an IDS meter
(see operating manual of the meter)
Calibration details may vary depending on the device selected.
CCESSORIES
system is in operation
ET
system operating manual).
ET
N
ENSOR
ET
ALIBRATION PROCEDURE ON THE
N
ET
)
N
.
ENSOR
ET
pH
15