Connecting The Ids Sensor - Xylem wtw MIQ/IDS Operating Manual

Installation
14
Component
IDS sensors
3.7

Connecting the IDS sensor

1. Connect the IDS plug of the sensor cable to an IDS interface of the MIQ/
IDS module.
The sensor data are displayed on the IQ S
measured value display.
figure 3-1 Display of a sensor in the measured value display (example: pH sensor)
For functions, settings and further information on the connected sensor,
see the following sections in the operating manual.
IDS sensors are displayed in the IQ S
for the sensor type (e.g. "IDS pH").
The series number may be shortened.
The original sensor name and the original series number can be
displayed in the status info of the sensor int he menu
Settings/Service/List of all components
operating manual).
Power supply
The connected IDS sensors are supplied
with power via the MIQ/IDS module (see
section 11.2).
ENSOR
N
ENSOR
(see IQ S
ba77277d01
MIQ/IDS
N terminal in the
ET
with a group name
ET
Einstellungen/
N system
ENSOR ET
01/2024