Changing The Planetary-Gear-Drive Lubricant - Toro Multi Pro 5800-D Operator's Manual

Figure 89
1. Fill plug
2. Fill-plug hole (planetary
lubricant)
5. Check the O-rings of the fill plug for the damage.
If the O-ring is damaged, replace it.
6. Install the fill plug and the check plug
7. Repeat steps 1 through
drive at the other side of the machine.
Changing the
Planetary-Gear-Drive
Lubricant
Service Interval: After the first 50 hours
Every 800 hours or yearly, whichever comes
first.
Draining the Planetary-Gear-Drive
Lubricant
1. With the machine on a level surface, position a
wheel so that the fill plug is at the highest (12
o'clock) position and the drain plug is at the
lowest (6 o'clock) position; refer to
Checking the Planetary-Gear-Drive Lubricant
(page 66).
2. Place a drain pan under the hub of the
planetary-gear drive, remove the drain plug, fill
plug, and the check plug, and allow the lubricant
to drain completely
3. Check plug
(Figure
6 for the planetary-gear
Figure 87
(Figure 90).
1. Fill plug
g238948
2. Fill-plug hole (planetary
lubricant)
3. Check-plug hole
(planetary lubricant)
3. Examine the drain and fill plugs for metal
shavings.
If fill drain and fill plugs are covered with metal
shavings, repair the planetary-gear drive.
89).
4. Check the O-rings of the drain plug, fill plug, and
the check plug for the damage.
If the O-ring(s) is damaged, replace it.
5. Install the drain plug.
6. Place a drain pan under the brake housing,
remove the drain plug, and allow the lubricant to
drain completely
1. Drain hole (brake housing) 2. Drain plug
in
7. Install the drain plug in the brake housing.
67
Figure 90
4. Drain-plug hole (planetary
lubricant)
5. Drain plug
6. Check plug
(Figure 91).
Figure 91
g238951
g238950