Toro Multi Pro 5800-D Operator's Manual page 82

Figure 115
1. Manifold (agitation valve)
2. Valve support
3. Flange locknut (1/4 inch)
4. Remove the agitation-valve manifold and
gaskets from the machine
Note:
If needed, loosen the mounting hardware
for the pressure-filter head as needed to provide
clearance.
Note:
Retain the flange clamps, gaskets, and
quick-connect pins for installation in
the Agitation-Manifold Valve (page
Removing the Section-Manifold
Valve
1. Remove the quick-connect pin that secures the
quick-connect coupler for the section-bypass
valve to the section-manifold valve
g191302
4. Flange-head bolt (1/4 x
3/4 inch)
5. Gasket
(Figure 115).
Installing
86).
(Figure 116).
1. Section-bypass valve
2. Quick-connect pins
2. Remove the quick connect pin that secures the
quick-connect coupler for the section supply
hose to the manifold for the quick-connect fitting
of the section-manifold valve
3. Remove the 2 flange clamps that secure the
section-manifold valve to the flanges of the
adjacent components
1. Flange (coupling adapter)
2. Flange (section-manifold
valve)
4. For left or right section-valve manifolds, remove
the 2 flange-head bolts (1/4 x 3/4 inch) and
2 flange locknuts (1/4 inch) that secure the
section-valve manifold to the valve support
(Figure 118).
82
Figure 116
3. Quick-connect coupler
(section supply hose)
4. Quick-connect fitting
(agitation valve manifold)
(Figure 116).
(Figure 117).
Figure 117
3. Section-manifold valve
4. Flange clamps
g191303
g191300