Drive System Maintenance; Inspecting The Wheels/Tires; Changing The Planetary Gearbox Fluid - Toro 41594 Operator's Manual

Storing the Battery
If the machine will be stored for more than 30 days, remove
the battery and charge it fully. Either store it on the shelf or on
the machine. Leave the cables disconnected if it is stored on
the machine. Store the battery in a cool atmosphere to avoid
quick deterioration of the charge in the battery. To prevent
the battery from freezing, ensure that it is fully charged.
Drive System
Maintenance

Inspecting the Wheels/Tires

Service Interval: After the first 8 hours—Torque the wheel
lug nuts.
Every 100 hours—Torque the wheel lug nuts.
Every 100 hours—Inspect the condition and wear of
the tires.
Torque the front lug nuts to 75 to 102 N-m (55 to 75 ft-lb)
and the rear lug nuts to 95 to 122 N-m (75 to 90 ft-lb).
Operating accidents, such as hitting curbs, can damage a
tire or rim and also disrupt wheel alignment, so inspect tire
condition after an accident.
Changing the Planetary
Gearbox Fluid
Service Interval: After the first 8 hours
Every 400 hours
Change the planetary gearbox fluid in each rear wheel after
the first 8 hours and then after every 400 hours thereafter.
Use high quality, SAE 85W-140 weight gear lube.
1. Position the sprayer on a level surface with the rear
wheels positioned for draining as illustrated in
66.
1. Drain plugs, positioned for draining
2. Set the parking brake, stop the pump, stop the engine,
and remove the key from the starter switch.
3. Place a pan under the drain plugs and remove them
from the wheel
4. Place a pan under the inner drain plug and remove it
(Figure 67).
51
Figure 66
(Figure 66).
Figure