Toro Multi Pro 5800-D Operator's Manual page 85

Installing the Section-Manifold
Valve
1. Align the 2 gaskets that you removed in
Removing the Section-Manifold Valve (page
82) to the flanges of the section-valve manifold
(Figure 123).
Note:
If needed, loosen the mounting hardware
for the left or right section-valve manifolds as
needed to provide clearance.
Figure 123
1. Flange locknut (1/4
inch—left and right
section-valve manifold
positions)
2. Section-bypass valve
3. Quick-connect fitting
(section-valve manifold)
2. Align the flange of the section-valve manifold
between the flanges of the other section-valve
(s) and/or coupling adapter
3. Assemble the quick-connect fitting of the
section-valve manifold to the quick-disconnect
socket of the section-bypass valve with a
quick-connect pin
4. Flange (coupling adapter)
5. Gasket
6. Flange-head bolt (1/4 x
3/4 inch—left and right
section-valve manifold
positions)
(Figure 123).
(Figure 123 and Figure
1. Section-bypass valve
2. Quick-connect pins
4. Loosely assemble the flange clamps that you
removed in
Valve (page 82)
section-valve manifold and the flanges of the
other section-valve (s) and/or coupling adapter
g191304
(Figure
124).
1. Flange (coupling adapter)
2. Flange (section-manifold
valve)
5. For left or right section-valve manifolds,
assemble the section-valve manifold to the valve
support
bolts (1/4 x 3/4 inch) and 2 flange locknuts
(1/4 inch) that you removed in
Section-Manifold Valve (page
85
Figure 124
3. Quick-connect coupler
(section supply hose)
4. Quick-connect fitting
(agitation valve manifold)
Removing the Section-Manifold
to the flanges of the
125).
Figure 125
3. Section-manifold valve
4. Flange clamps
(Figure 123) with the 2 flange-head
85).
g191303
g191300
Installing the