Toro Multi Pro 5800-D Operator's Manual page 36

Figure 39
1. Application-rate mode
position
4. Move the sprayer to the area of turf that you
are spraying.
5. If you are collecting area sprayed and volume
sprayed data for each job site, select a sub-area
screen (sub-areas 1 through 20) to record for
the individual area and volume information; refer
to Using the Sub-Area Screen in the Software
Guide for the Multi Pro 5800-D and 5800-G turf
sprayer with ExcelaRate spray system.
Note:
When you move to a different job site,
you need to select another sub-area screen
to record the individual area and volume
information.
6. If you need to switch the active rate between
the rate 1 value and the rate 2 value, from the
InfoCenter home screen press buttons 1 and 2
simultaneously to select
4 and 5 simultaneously to select
to the Software Guide for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system.
7. Set the spray section switch(es) to the O
position (Figure 40).
g193437
2. Sprayer-mode switch
1 or press buttons
RATE
2; Refer
RATE
N
1. Left spray-section switch
2. Center spray-section
switch
8. Set the agitation switch and the spray-pump
switch to the O
1. Sprayer-pump switch
2. Agitation switch
9. Set the throttle to the F
10. Drive at the desired speed and then set the
master section switch to the O
spraying (Figure
Note:
Use the master section switch to start
and stop the flow of chemical s to the selected
spray sections.
11. When finished spraying, set the master section
switch to the O
36
Figure 40
3. Right spray-section switch
4. Master section switch
position (Figure 41).
N
Figure 41
3. Throttle
position (Figure
AST
position to begin
N
40).
position to turn off all spray
FF
g192944
g192636
41).