Replacing The Air-Filter Element - Toro Multi Pro 5800-D Operator's Manual

7. Check the air-filter element for excessive
accumulation of dust, dirt, and debris
72).
Note:
Do not clean the air-filter element if it is
dirty; replace the air-filter element if it is dirty.
8. Install the dust cap onto the air-cleaner body and
secure the cap with the 2 latches
Note:
Ensure that the dust valve aligns
between the 5 to 7 o'clock position when viewed
from the end.
9. Lower the passenger seat.
Replacing the Air-Filter
Element
Service Interval: Every 100 hours Replace the
air-filter element more often in dusty,
dirty conditions.
1. If you are installing a new filter, inspect the new
air-filter element for shipping damage, including
the sealing end of the filter.
Important:
Do not install a damaged filter.
2. Clean the dust cap and air-cleaner body
72).
3. Lift the coolant-overflow tank up and off the
tank-support bracket
(Figure
(Figure 72).
(Figure
(Figure 73).
1. Coolant-overflow tank
2. Tank-support bracket
3. Latch (dust cap)
4. Dust cap
4. Loosen the 2 latches that secure the dust cap to
the air-cleaner body
5. Gently slide the old filter element out of the
air-cleaner body to reduce the amount of dust
dislodged.
Note:
Avoid knocking the filter element against
the air-cleaner body.
6. Clean the inside of the dust cap, air-cleaner
body, and dust valve with a damp rag
72 and Figure
7. Insert the air-filter element into the air-cleaner
body (Figure
Note:
Ensure that the filter is seated in the
air-cleaner body properly by applying pressure
to the outer rim of the filter element when you
install it. Do not press on the flexible center part
of the filter.
57
Figure 73
5. Air-filter element
6. Dust valve (5 to 7 o'clock
position)
7. Pressure-relief hose
8. Tank-vent hose
(Figure 73).
73).
73).
g032541
(Figure