Toro Multi Pro 5800-D Operator's Manual page 21

Figure 19
1. Actuator (agitation valve)
2. Agitation-bypass-valve
handle
Flowmeter
The flowmeter measures the flow rate of the fluid for
use by the InfoCenter system and when spraying in
the application rate mode
Agitation-Throttle Valve
The agitation-throttle valve is a manually-operated
ball valve that controls flow to the agitation nozzles
in the main tank. This valve allows you to control
the sprayer-system pressure at the agitation nozzles
of the main tank when larger application rates are
required. The agitation-throttle valve is located above
the pump (Figure 20).
Figure 20
1. Agitation-throttle-valve handle
3. Flow meter
(Figure 19).
Section Bypass Valves
The section bypass valves are used to adjust the
sprayer system pressure to the section valves to
ensure that the sprayer pressure to the spray section
remains constant no matter how many spray sections
are on (Figure
Note:
Use the bypass valves when spraying in the
manual mode (open loop) only.
g194246
1. Knob (section-bypass
valves)
Section-Bypass Shutoff Valve
Use the section-bypass shutoff valve to control fluid
flow from the section bypass valves to the tank when
spraying in the manual mode (open loop); refer to
Figure 21.
Note:
Close the section-bypass shut off valve when
spraying in the application rate mode (closed loop).
Anti-Siphon Fill Receptacle
At the front of the tank cover is a hose receptacle
with a threaded fitting, a 90-degree barbed fitting,
and a short hose, which you can direct toward the
tank opening. This receptacle allows you to connect
a water hose to it and fill the tank with water without
contaminating the hose with the chemicals in the tank.
Important:
Do not lengthen the hose to allow
g032528
contact with the tank fluids. The distance from
the end of the hose to the uppermost water level
should be within local regulatory limits.
21
21).
Figure 21
2. Section-bypass shutoff
valve
g190774