Toro Multi Pro 5800-D Operator's Manual page 83

Figure 118
1. Flange locknut (1/4
inch—left and right
section-valve manifold
positions)
2. Section-bypass valve
3. Quick-connect fitting
(section-valve manifold)
5. Move the section-valve manifold and gaskets
down to clear the section-bypass valve and then
away from the machine
Note:
If needed, loosen the mounting hardware
for the left or right section-valve manifolds as
needed to provide clearance.
Note:
Retain the flange clamps, gaskets and
quick-connect pins for installation in
the Section-Manifold Valve (page
Cleaning the Manifold Valve
1. Position the valve stem so that it is in the closed
position (Figure 119B).
g191304
4. Flange (coupling adapter)
5. Gasket
6. Flange-head bolt (1/4 x
3/4 inch—left and right
section-valve manifold
positions)
(Figure 118).
Installing
85).
1. Valve open
2. Remove the 2 end-cap-fitting assemblies from
each end of the manifold body
Figure 121).
Agitation Valve Manifold
1. Stem retainer
2. Valve stem
3. Stem port
4. Stem-capture retainer
5. End-cap fitting
6. End-cap seal O-ring
(0.796 x 0.139 inch)
83
Figure 119
2. Valve closed
(Figure 120
Figure 120
7. Back seating O-ring (0.676
x 0.07 inch)
8. Valve-seat ring
9. Manifold body
10. Ball valve
11. End-cap-fitting assembly
g027562
and
g028243