Toro Multi Pro 5800-D Operator's Manual page 49

Maintenance Service
Interval
Every 400 hours
Every 800 hours
Every 1,000 hours
Every 2,000 hours
Yearly
Maintenance Procedure
• Grease the actuator-rod bearings.
• Perform yearly engine maintenance.
• Check the fuel lines and connections.
• Replace the fuel-filter canister.
• Replace the in-tank fuel filter.
• Drain and clean the fuel tank.
• Pack the front wheel bearings.
• Check the planetary-gear-drive lubricant.
• Check the coolant (as directed by the manufacturer) and change if necessary.
• Inspect the O-rings in the valve assemblies and replace them if necessary.
• Change the suction filter.
• Change the pressure filter.
• Inspect the nylon pivot bushings.
• Inspect the pump diaphragms and replace if necessary (see an authorized Toro
distributor).
• Inspect the pump check valves and replace if necessary (see an authorized Toro
distributor).
• Change the planetary-gear-drive lubricant. or yearly, whichever comes first.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, replace the hydraulic filter.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, change the hydraulic fluid.
• If you are using the recommended hydraulic fluid, replace the hydraulic filter.
• If you are using the recommended hydraulic fluid, change the hydraulic fluid.
• Calibrate the agitation-bypass valve.
49