Replacing The Fuel Filter - Toro 41164 Operator's Manual

Greasing the Boom Pivot Arms
The boom pivot arms are not greased at the time of factory
assembly and must be greased before use.
Grease Type: No. 2 general-purpose lithium base grease.
1. Manually place grease on the support shaft and within
the ball seat of the hinge plate as shown in Figure 41.
2. Pump grease into the fitting located below the spring
until grease can be seen coming out of the bottom of the
pivot assembly (Fig.41).
3. Repeat the procedure for opposite pivot arm.
1
3
4
1
Figure 41
Left pivot arm shown
1. Support shaft
2. Ball seat of hinge plate
2
3. Grease fitting
4. Pivot assembly
36

Replacing the Fuel Filter

Replace the fuel filter after every 100 operating hours.
1. Set the parking brake, stop the pump, stop the engine,
and remove the ignition key.
2. Release the latch on the back of the seat and lift the seat
forward.
3. Clamp off the hose on either side of the fuel filter to
prevent gas from pouring out of the hoses when you
remove the filter.
4. Place a drain pan under the filter.
5. Squeeze the ends of the hose clamps together and slide
them away from the filter (Fig. 42).
6. Remove the filter from the fuel lines.
3 4
Figure 42
1. Hose clamp
2. Fuel line
7. Install a new filter and move the hose clamps close to
the filter.
Ensure that the flow direction arrow points toward the
engine.
1
2
m–3365
3. Filter
4. Flow direction arrow