Power On And Off - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction Introduction

Power On and Off

Power On/Off with the Power button
The power button, with LED indicator, is placed on the front as shown in the illustration.
Switch on
If the video system does not
start automatically, press the
power button gently, and hold
for a few seconds.
The LED is lit while the video
system starts up.
D15330.02 SX10 Administrator Guide CE8.1, APRIL 2016.
Configuration Peripherals
Power button with
Switch off
Press the power button gently
and hold until the light goes out.
Maintenance
LED indicator
Enter/exit standby mode
Press the power button briefly.
It takes a few seconds before
the unit enters standby.
15
Administrator Guide
System settings
Power Off or restart the system remotely
Sign in to the web interface and navigate to
Restart.
Restart the system
Click Restart device... and confirm your choice.
It takes a few minutes before the system is ready for use.
Power Off the system
Click Shutdown device... and confirm your choice.
You cannot power On the system remotely.
Restart and standby using the remote
control or Touch controller
Restart the system
1. Select the settings icon (cogwheel) on the home
screen, or in the status bar of the Touch controller.
2. Select System Information > Restart
control, or Settings > Restart on the Touch controller.
3. Select Restart again, and confirm your choice.
Enter/exit standby mode
1. Select the settings icon (cogwheel) on the home
screen, or in the status bar of the Touch controller.
2. Select Standby.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Appendices
Maintenance >
with the remote