Table of Contents
Advertisement
2.9 Network Setup
Set the IP address
On the front panel display:
1. Press the Network menu button
2. Select your Ethernet port: press the down button once to highlight Eth0 or press the
3. Navigate to the IP address section. Highlight the current setting. To change the set-
In the CLI:
In the Web UI:
1. Navigate to
2.
3. Click Submit after all your changes have been entered, and start a new Web UI ses-
To continue with other settings, such as NTP preferences, references, outputs, etc., see
the main user manual: safran-navigation-timing.com/manuals.
32
Note:
DHCP must be disabled before you can configure a static IP address
(see above)
RIGHT button to select Eth1
ting, press the verification button on the keypad, use the keypad directional arrows
to choose the desired setting, and press the verification button twice to confirm your
choice.
Use the command: ip4set <intfc> <addr> <mask> [<gateway>] where
is eth0 or eth1;
intfc
addr
the subnet mask (for instance, 255.255.255.0) and the
work gateway.
MANAGEMENT
Click on the gear icon next to an Ethernet port. The Edit Ethernet Port Settings
window will open. To change network settings for that port, including the IP address,
enter your static IP address, netmask, and gateway (if needed).
sion by entering the new IP address into your browser and logging in.
is the IPv4 address, (such as 192.168.100.12),
>
>
NETWORK
Network
SecureSync 2400 Getting Started Guide Rev. 4
mask
is the (optional) net-
gateway
Setup.
is
Advertisement
Table of Contents
