Safran SecureSync 2400 Getting Started Manual page 37

Disable or Enable DHCP
In order to assign an IP address to an Ethernet port, it is necessary to disable DHCP.
On the front panel display:
In the CLI:
In the Web UI:
SecureSync 2400 Getting Started Guide Rev. 4
1. Navigate to
MANAGEMENT
2. Click on the information icon next to an Ethernet port to view all network settings for
that port.
I d e n t i f y y o u r I P a d d r e s s u s i n g Z E R O C O N F
For when you don't have physical access to the unit or have "lost" your unit on a network.
1. Identify the MAC address (e.g., "00 0C EC 0E 51 7B"): on the serial number label on the side of
your unit, on the front panel display in the Network menu, or through the CLI using the
command.
2. On a computer connected to the same LAN as your SecureSync, open your browser and (in the
URL field) type the following:
where [xxxxxx] of the hostname is the last six digits of the MAC address (e.g., "0E 51 7B").
You should now be connected to the unit Web UI and can login using the default credentials.
1. Press the Network
2. Select your Ethernet port: press the down button once to highlight Eth0 or press the
RIGHT button to select Eth1
3. Navigate to the DHCP section. Highlight the current setting (either ON or OFF). To
change the setting, press the verfication button on the keypad, use the keypad dir-
ectional arrows to choose the desired setting, and press the verification button twice
to confirm your choice.
Use the following command to set DHCP:
dhcp4set <intfc> <on|off>, where the intfc is either
1. Navigate to
MANAGEMENT
2. Click on the gear icon next to an Ethernet port to change network settings for that
port. If you are disabling DHCP, it is recommended to enter your settings before
clicking Submit to avoid errors (see next section).
>
NETWORK
securesync-[xxxxxx].local/
menu button
>
NETWORK
2.9 Network Setup
>
Network Setup.
eth0
>
Network Setup.
ifconfig
or eth1.
31