Out Digital Output - Zmotion ZIO Series Manual

→ Wiring Note:
The wiring principle of digital input IN (0-15) is shown in the figure above. The
⚫
external signal source can be an optocoupler, a key switch or a sensor, etc., all can
be connected as long as the requirements on output of electric level can be achieved.
For the public end, please connect the "EGND" port on the IO power supply to the
⚫
"COM" terminal of the external input device. If the signal area power supply of the
external device and the power supply of the controller are in the same power supply
system, this connection also can be omitted.

3.7.4. OUT Digital Output

→ Wiring Definition
Terminal Name Type
E24V /
EGND /
OUT7
OUT6
OUT5
OUT4
NPN leakage type,
OUT3 digital output
OUT2
OUT1
OUT0
EGND /
EGND /
OUT15
OUT14
OUT13
NPN leakage type,
OUT12
digital output
OUT11
OUT10
OUT9
Function 1
IO power input DC24V
IO power ground
Output 7
Output 6
Output 5
Output 4
Output 3
Output 2
Output 1
Output 0
IO power ground
IO power ground
Output 15
Output 14
Output 13
Output 12
Output 11
Output 10
Output 9