Table of Contents
Advertisement
→ Wiring Note:
⚫
The wiring principle of digital input IN (0-7) is shown in the figure above. The external
signal source can be an optocoupler, a key switch or a sensor, etc., all can be
connected as long as the requirements on output of electric level can be achieved.
For the public end, please connect the "EGND" port on IO power supply to the "COM"
⚫
terminal of the external input device. If the signal area power supply of the external
device and the power supply of the controller are in the same power supply system,
this connection also can be omitted.
3.1.4. OUT Digital Output
→ Wiring Definition
Terminal
Name
Type
EGND
/
E24V
/
OUT0
OUT1
OUT2
OUT3
NPN leakage type,
digital output
OUT4
OUT5
OUT6
OUT7
Function 1
IO power ground
IO power input DC24V
Output 0
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
Output 7
Advertisement
Table of Contents
