Table of Contents
Advertisement
3.2.4. Expansion Module Usage
(1) Please follow the above wiring instructions to do power, CAN, and IO signal wiring
correctly.
(2) Assign IO address and communication speed ratio through DIP switch.
(3) After powered on, please use ETHERNET or RS232 to connect to ZDevelop.
(4) Please use the "CANIO_ADDRESS" command to set the master's "address" and
"speed" according to the needs, and use the "CANIO_ENABLE" command to enable or
disable the internal CAN master function.
(5) After all the settings are completed, it is time to communicate, in "State the
controller"--"CAN nodes", it will show information of expansion module.
(6) Open or close output port directly through "OP" command, also, it can be opened or
closed through "ZDevelop/View/Op". Please refer to "ZBasic" for details.
Advertisement
Table of Contents
